Instructions

To illuminate the display for 1,5 seconds, press the button "C".

Modes

You can change the modes by pressing the button "B". The modes are in a following order:

1. Timekeeping : Default mode. This mode shows the current time and date. The time can be shown in 12-hour and 24-hour modes.
2. Calculator : This mode performs arithmetic calculations.
3. Stopwatch : This mode measures an elapsed time and shows a split time.

Changing the mode in the Stopwatch mode brings you back to the Timekeeping mode.

Timekeeping

To change between the 12-hour and 24-hour modes, press the button "D".

Calculator

To calculate, use the keypad. :)

Press the button "D":

• to cancel number you have just inputted.
• to clear a current calculation (after you have pressed the keypad button "=").

To continue the calculation, just press some arithmetic operator button ("+", "−", "×" or "÷") and input another number.

To start the new calculation after pressing the keypad button "=", just input some new number.

To change the arithmetic operator, press some other arithmetic operator button.

If the calculation results in an error, the letter "E" is shown. To clear the error and start the new calculation, press the button "D". The error occurs if the calculation result is more than eight digits long (the limitation of the model "Casio Multi Lingual Data Bank DBC-32).

Stopwatch

To start measuring the elapsed time, press the button "D". To stop measuring it, press the button "D" again.

Changing the mode stops the timing but doesn't clear it. So when you get back to the Stopwatch mode, it shows the time as it was just before changing the mode.

Elapsed time

D	>	D	>	D	>	D	>	A
Starts the timing		Stops the timing		Re-starts the timing		Stops the timing		Clears the timing

Split time

D	>	A	>	A	>	D	>	A
Starts the timing		Shows the split time ("SPL" can be seen in the upper left corner of the display)		Hides the split time		Stops the timing		Clears the timing